Recent Posts

Pages: 1 [2] 3 4 ... 10
11
Telechron & GE Clocks / Re: Ratched on Netflix
« Last post by Mrbill5 on September 19, 2020, 08:17:35 PM »
Too bad I do not want anything to do with the kiddieporn folks at.Netflix
12
Telechron & GE Clocks / Ratched on Netflix
« Last post by Larry from Canada on September 19, 2020, 07:30:20 PM »
Many telechron sightings in this show.
13
Telechron & GE Clocks / Re: 6H50 Jason
« Last post by max9090 on September 18, 2020, 11:34:06 PM »
Clockhistory.com has a catalog with a large number of parts list for Telechron/GE. The Jason is listed under "Striking Clocks."
14
Telechron & GE Clocks / Re: 6H50 Jason
« Last post by max9090 on September 18, 2020, 09:51:54 PM »
Just by way of information - the 5H66 sweep hand assembly is part #XC16X2. The sweep hand assembly for the 6H50 is part # XC16X3.
15
Telechron & GE Clocks / Re: Need knurled Knob for 7H85
« Last post by TIME2TIME on September 18, 2020, 08:02:44 PM »
I have one. You can have it. For free. For real.

I sent you my address.

thanks very much.
16
Telechron & GE Clocks / Re: Need knurled Knob for 7H85
« Last post by TIME2TIME on September 18, 2020, 07:57:13 PM »
3-48 threading

ah, thanks.  Never seen a #3 screw.
17
Telechron & GE Clocks / Re: Need knurled Knob for 7H85
« Last post by max9090 on September 18, 2020, 07:33:21 PM »
I have one. You can have it. For free. For real.
18
Telechron & GE Clocks / Re: Forum Notice
« Last post by Mrbill5 on September 18, 2020, 06:38:45 PM »
I am guilty as charged.
Pappy, thanks for the website.  Unbelievable amount of info .
19
Telechron & GE Clocks / Re: Need knurled Knob for 7H85
« Last post by Mrbill5 on September 18, 2020, 06:36:19 PM »
3-48 threading
20
Telechron & GE Clocks / Re: Need knurled Knob for 7H85
« Last post by TIME2TIME on September 18, 2020, 05:35:06 PM »
On this clock both are clockwise.  I Tried the large knob that I have and it screws on both shafts.

I couldn't get a 2-56 hex to thread on either shaft, but it threads on a 2-56 screw that threads into my knob..if that makes sense...  so I guess the thread is something close to 2-56.
Pages: 1 [2] 3 4 ... 10
SMF spam blocked by CleanTalk